Global Home Digital AV Support > TV > Download > Firmware Update Procedure for Life Design Models (Monitor)

Firmware Update Procedure for Life Design Models (Monitor)

Firmware Update Procedures for Asia

Step 3. Copy the firmware file onto an USB flash memory.

Preparation of the USB flash memory

Please prepare a formatted USB flash memory with more available free space than the self-extracted file.
Note : When formatting the USB flash memory, all data (including protected data) will be erased and can not be recovered. Please ensure you back up your important data so you don't lose it.

Insert your formatted USB flash memory to your USB slot of your PC.

Copy the file into the Root directory (*1) of the USB flash memory.
(*1) Root directory = The first or top-most directory in the hierarchy.

Step 4. Install the firmware update.

  1. Turn on the product.
  2. Insert the USB flash memory prepared in STEP 3 into the USB terminal of your monitor.
    Please use USB 1 input of your monitor.


  3. Press OK button.


  4. Select "Yes" and press OK button.


  5. Please wait until download is completed.


  6. When the update is finished, the following screen will display.
    The text may differ depending on the model, but please follow the instructions on the screen.
    • for OLED Models
    1. Remove the USB flash memory from Monitor.
    2. Point the remote control at the remote control signal receiver.
    3. Press the power button on the remote control for 10 seconds or more, then release your finger.
    		  
    • for LCD Models
    1. Remove the USB flash memory from Monitor.
    2. Press and hold the main power switch on monitor for 5 seconds, then release it.
     

  7. A black screen will appear for a few seconds(max 5 minutes).


  8. When the download is finished the TV should start as usual.


  9. Confirm the new version of the system software. Refer to Step1.
    10. Note : If the update fails, please switch the set on and off at least 3 times and try again.
    The software update installation procedure for the monitor is now complete.
    Also, please be sure to confirm the software of transmitter is latest. If it is not, please update.
    Please confirm the software version by "Download Information of Life Design Models for Asia (Transmitter)".
 

If you have any problems after installing the new firmware, please contact the Global Service Center Network.