Global Home Support > Consumer Support > Digital AV > Audio > Download > SC-UA7 Software Update service

SC-UA7 Software Update service

Step 4. Decompress the downloaded file

Check the file size of the downloaded file and decompress it. (Supported for Windows only.)

  1. Checking the file size
    Right click on the downloaded software, and select "Properties". Make sure that the size of the file is the same as the size listed on the download page.
    If the file size differs, please download it again. After checking the size, click [OK] and the "Properties" window will close.
  2. Decompressing the file
    Double click the downloaded software and decompress it.
    The decompressed file will be named as "UA7.FRM".
UPDATE_UA7_V1_1_3.exe

File size is 1,460,336 bytes.

Step 5. Preparing the USB device

Before start creating the update USB device, please check update file to make sure it has correct file name.
It is important to use the correct file, otherwise USB version up process will not work.
Below is the file name and file for your reference:

Model
Region
File name
SC-UA7
All Region
UA7.FRM
  • Please prepare USB device which memory is less than 32GB and file format FAT or FAT32.(not support exFAT)
  • To create USB update, copy the FRM file (depends on model) into USB root folder.

Note:
Do not rename the file as the updating process will look for above naming. If different name, version up process will not work.

Step 6. Software Update
Caution:
  • During the updating process, do not disconnect the AC power supply cord.
  • Do not press any buttons, except as instructed. Failure to do so may result in the set becoming unresponsive which will require repair.
  • Set need to be turn ON in order to support USB update process.
  • Go to USB B selector.
Steps:
  1. Insert USB device (With UA7.FRM file inside).
  2. When "UPDATE" is displayed, press OK. Display will change to "OK? NO".
  3. Press [] button to change to "OK? YES".
  4. Press [OK] button.
  5. During update process, the display will gradually change from "UPD 0%" up to "UPD 100%".
  6. When "SUCCESS" display appears, unplug USB then AC out supply. Software updating process is now complete.
  7. NO NEED: the software is already latest version and no need to update.

Main unit display Software version display after updating (example: V1.06)

In the event the software update process is interrupted, please follow these steps. Please note that software recovery is possible in USB B port only.

  1. Unplug the AC power supply and remove the USB device from the USB B port.
  2. Plug in the AC power supply.
  3. When the set displays "WAIT", plug in the USB device back to USB B port.

     
    The display will then show "UPDATING", then it will proceed with the recovery process. The display will gradually change from "UPD 0%" up to "UPD 100%".
  4. Note:
    In case the set display does not change to "UPDATING", plug out and plug in the USB device to USB B port. Repeat this until the USB device is properly detected.

  5. When "SUCCESS" display appears, unplug USB then AC out supply. Software recovery process is now complete.