Creating new modes

You can create new modes to operate your devices when an event occurs such as motion is detected.

Access the mode screen (Accessing the mode screen).

Tap

Change the settings as required.

•

Each setting is explained in this section.

When finished, tap [Create].

Mode name

When creating a new mode, you can set the name used for the mode. This helps you to identify the mode from other modes used on your mobile device.

–

To enter a name: Tap the text field and enter the text.

Start Recording

You can enable and disable recording, and also specify the recording duration for each camera.

–

To enable/disable recording: Slide the switch next to each camera name to the desired position.

–

To select a recording duration: Tap the time displayed next to [Duration], and then tap [Done].

Sync

You can coordinate cameras so that when 1 camera detects motion, the other camera starts pre-recording. (Images are temporarily stored, and if motion is detected later, images are then saved on the access point’s SD card.)

–

To enable/disable camera coordination: Slide the [Sync] switch to the desired position.

Note:

•

Sync is only available when 2 or more front door cameras or outdoor cameras are registered to the access point.

[Send Notifications]

Push notifications are displayed on your mobile device when motion is detected.

–

To enable/disable push notifications: Slide the switch to the desired position.

Note:

•

After recording has started for a camera, motion detection notifications from that camera are not sent to mobile devices. However, motion detection notifications from other cameras are sent.

[Play Sound]

You can specify what sounds a camera will automatically make when motion is detected. This can be used to warn suspicious people approaching your house that they have been detected and that there are cameras that can record images of them.

Tap the setting value displayed next to [Play Sound].

Select the desired sound.

–

[Beep]: Sounds a beep when motion is detected.

–

[Announcement]: Plays a predetermined announcement when motion is detected.

•

This setting is only available for front door cameras.

•

This setting may not be available in some regions.

•

The available languages of announcements may differ depending on the region of use.

–

[OFF]: Disables sounds for motion detection.

When finished, tap [OK].

Note:

•

You can change the volume of beeps and announcements played form cameras. See Speaker volume settings for more information.