Configuring geo-fencing

You can specify the settings to be used with geo-fencing.

Access the mode screen (Accessing the mode screen).

Tap [Edit]

Tap

next to [Geo-fencing].

Change the settings as required.

•

Each setting is explained in this section.

Setting the base position and radius

In order to use geo-fencing, you must specify the location and size of the geo-fencing area. The base position (usually your home) determines where the geo-fence will be located and the radius determines the size of the geo-fencing area.

Setting the radius

Tap the size displayed next to [Radius].

Specify the desired size, and then tap [Done].

Setting the base position for iPhone, iPad

On the map displayed under [Position], tap and hold the area you want to specify for the base position.

Setting the base position for Android devices

Tap [Use current location] → [OK]. The location information of the mobile device is obtained and is used as the base location. After this, tap [Check Map] and confirm the location displayed on the map.

Note:

•

Although the position can be set using the map, it may not be set accurately.

Setting the mode for when you are not at home (out of radius).

You can specify the mode that will be used when your mobile device is outside of the specified radius around the geo-fencing area (i.e., when you are away from home).

This mode will be activated when all of the selected mobile devices (Selecting the mobile devices to use with geo-fencing) are out of the radius.

Tap [Out of Radius], select the mode, and then tap [Done].

Setting the mode for when you are at home (in radius)

You can specify the mode that will be used when your mobile device is inside of the specified radius around the geo-fencing area (i.e., when you are at home).

This mode will be activated when any one of the selected mobile devices (Selecting the mobile devices to use with geo-fencing) is in the radius.

Tap [In Radius], select the mode, and then tap [Done].

Selecting the mobile devices to use with geo-fencing

You can specify the mobile devices to be used with geo-fencing.

Tap [Select the Mobile Devices], specify the mobile devices to be used with geo-fencing, and then tap [OK].

Note:

•

All mobile devices in the list can be deselected. However, each mobile device can only be selected (enabled) by itself and not from other mobile devices.

•

A mobile device can only be selected for use with the geo-fencing settings of a maximum of 4 cameras.