SC-PM250 Software Update service

Perform the following steps.

• Step 1  Check the software version currently installed in your SC-PM250
• Step 2  Checking the latest software version available for your SC-PM250
• Step 3  Download the latest software
• Step 4  Decompress the downloaded file
• Step 5  Preparing the USB device
• Step 6  Software Update

Follow the steps below to check the software version currently installed on your SC-PM250

Steps
1. Turn on the main unit.
2. Press [SETUP] button repeatedly to select "SW VER." and then press [OK] button.

(Example of “Ver.1.00”)

Please make note of this version number.
Press [OK] button to exit this mode.

Confirm the latest software version that is available for "the Model Number of your SC-PM250" by referring the "Update Information" section provided above (near the top of this page).
Please compare this software version number to the version number of the software currently installed in your SC-PM250 (the software currently installed in your SC-PM250 was checked in "Step 1").

• If the version of the software installed on your SC-PM250 and the latest software version available are the same
  No update is necessary.
• If the version of the software installed on your SC-PM250 is lower than the latest version available
  Update is recommended - Please continue to step 3.

If the version of the software installed on your SC-PM250 is lower than the latest version of the software available , please download the latest version of the software.
Use of software downloaded from this site requires agreement with the License Agreement. Please review the contents of the License Agreement beforehand.